more nuvoton support

- add LED for nutiny nuc 121, 125s, 126v
- flash target to use nuvoton's openocd fork

hw/bsp/nutiny_nuc121s/board.mk

@@ -51,5 +51,8 @@ FREERTOS_PORT = ARM_CM0
 JLINK_DEVICE = NUC121SC2AE
 JLINK_IF = swd
 
-# flash using jlink
-flash: flash-jlink
+
+# Flash using Nuvoton's openocd fork at https://github.com/OpenNuvoton/OpenOCD-Nuvoton
+# Please compile and install it from github source
+flash: $(BUILD)/$(BOARD)-firmware.elf
+	openocd -f interface/nulink.cfg -f target/numicroM0.cfg -c "program $< verify reset exit"

hw/bsp/nutiny_nuc121s/nutiny_nuc121.c

@@ -29,6 +29,11 @@
 #include "clk.h"
 #include "sys.h"
 
+#define LED_PORT              PB
+#define LED_PIN               4
+#define LED_PIN_IO            PB4
+#define LED_STATE_ON          0
+
 void board_init(void)
 {
   /* Unlock protected registers */
@@ -60,6 +65,9 @@ void board_init(void)
   // 1ms tick timer
   SysTick_Config(48000000 / 1000);
 #endif
+
+  // LED
+  GPIO_SetMode(LED_PORT, 1 << LED_PIN, GPIO_MODE_OUTPUT);
 }
 
 #if CFG_TUSB_OS  == OPT_OS_NONE
@@ -81,7 +89,7 @@ uint32_t board_millis(void)
 
 void board_led_write(bool state)
 {
-  (void)(state);
+  LED_PIN_IO = (state ? LED_STATE_ON : (1-LED_STATE_ON));
 }
 
 uint32_t board_button_read(void)