change default port some stm bsp

- f769disco default port is highspeed port1
- remove PORT0 on stlink since the board only populated HS connector

hw/bsp/stlinkv3mini/board.mk

@@ -1,5 +1,3 @@
-PORT ?= 1
-
 CFLAGS += \
   -flto \
   -mthumb \
@@ -11,14 +9,8 @@ CFLAGS += \
   -DSTM32F723xx \
   -DHSE_VALUE=25000000 \
   -DCFG_TUSB_MCU=OPT_MCU_STM32F7 \
-  -DBOARD_DEVICE_RHPORT_NUM=$(PORT)
-
-ifeq ($(PORT), 1)
-CFLAGS += -DBOARD_DEVICE_RHPORT_SPEED=OPT_MODE_HIGH_SPEED
-$(info "PORT1 HS")
-else
-$(info "PORT0")
-endif
+  -DBOARD_DEVICE_RHPORT_NUM=1 \
+  -DBOARD_DEVICE_RHPORT_SPEED=OPT_MODE_HIGH_SPEED
 
 # mcu driver cause following warnings
 CFLAGS += -Wno-error=shadow -Wno-error=cast-align

hw/bsp/stm32f723disco/board.mk

@@ -1,4 +1,5 @@
-PORT ?= 0
+# Default is Highspeed port
+PORT ?= 1
 
 CFLAGS += \
   -flto \
@@ -14,10 +15,10 @@ CFLAGS += \
   -DBOARD_DEVICE_RHPORT_NUM=$(PORT)
 
 ifeq ($(PORT), 1)
-CFLAGS += -DBOARD_DEVICE_RHPORT_SPEED=OPT_MODE_HIGH_SPEED
-$(info "PORT1 HS")
+  CFLAGS += -DBOARD_DEVICE_RHPORT_SPEED=OPT_MODE_HIGH_SPEED
+  $(info "PORT1 High Speed")
 else
-$(info "PORT0")
+  $(info "PORT0 Full Speed")
 endif
 
 # mcu driver cause following warnings

hw/bsp/stm32h743eval/board.mk

@@ -1,3 +1,6 @@
+# Default is Highspeed port
+PORT ?= 1
+
 CFLAGS += \
   -flto \
   -mthumb \
@@ -8,8 +11,14 @@ CFLAGS += \
   -nostdlib -nostartfiles \
   -DSTM32H743xx \
   -DCFG_TUSB_MCU=OPT_MCU_STM32H7 \
-	-DBOARD_DEVICE_RHPORT_NUM=1 \
-	-DBOARD_DEVICE_RHPORT_SPEED=OPT_MODE_HIGH_SPEED
+	-DBOARD_DEVICE_RHPORT_NUM=$(PORT)
+
+ifeq ($(PORT), 1)
+  CFLAGS += -DBOARD_DEVICE_RHPORT_SPEED=OPT_MODE_HIGH_SPEED
+  $(info "PORT1 High Speed")
+else
+  $(info "PORT0 Full Speed")
+endif
 
 # suppress warning caused by vendor mcu driver
 CFLAGS += -Wno-error=maybe-uninitialized -Wno-error=cast-align