added lpcxpresso 55s28

hw/bsp/lpc55/family.mk

@@ -2,6 +2,9 @@ UF2_FAMILY_ID = 0x2abc77ec
 
 include $(TOP)/$(BOARD_PATH)/board.mk
 
+# TODO change Default to Highspeed PORT1
+PORT ?= 0
+
 CFLAGS += \
   -flto \
   -mthumb \
@@ -11,18 +14,26 @@ CFLAGS += \
   -mfpu=fpv5-sp-d16 \
   -DCFG_TUSB_MCU=OPT_MCU_LPC55XX \
   -DCFG_TUSB_MEM_SECTION='__attribute__((section(".data")))' \
-  -DCFG_TUSB_MEM_ALIGN='__attribute__((aligned(64)))'
+  -DCFG_TUSB_MEM_ALIGN='__attribute__((aligned(64)))' \
+  -DBOARD_DEVICE_RHPORT_NUM=$(PORT)
+
+ifeq ($(PORT), 1)
+  CFLAGS += -DBOARD_DEVICE_RHPORT_SPEED=OPT_MODE_HIGH_SPEED
+  $(info "PORT1 High Speed")
+else
+  $(info "PORT0 Full Speed")
+endif
 
 # mcu driver cause following warnings
 CFLAGS += -Wno-error=unused-parameter -Wno-error=float-equal
 
-MCU_DIR = hw/mcu/nxp/sdk/devices/LPC55S69
+MCU_DIR = hw/mcu/nxp/sdk/devices/$(MCU_VARIANT)
 
 # All source paths should be relative to the top level.
-LD_FILE ?= $(MCU_DIR)/gcc/$(MCU_VARIANT)_flash.ld
+LD_FILE ?= $(MCU_DIR)/gcc/$(MCU_CORE)_flash.ld
 
 SRC_C += \
-	$(MCU_DIR)/system_$(MCU_VARIANT).c \
+	$(MCU_DIR)/system_$(MCU_CORE).c \
 	$(MCU_DIR)/drivers/fsl_clock.c \
 	$(MCU_DIR)/drivers/fsl_gpio.c \
 	$(MCU_DIR)/drivers/fsl_power.c \
@@ -38,7 +49,7 @@ INC += \
 	$(TOP)/$(MCU_DIR) \
 	$(TOP)/$(MCU_DIR)/drivers
 
-SRC_S += $(MCU_DIR)/gcc/startup_$(MCU_VARIANT).S
+SRC_S += $(MCU_DIR)/gcc/startup_$(MCU_CORE).S
 
 LIBS += $(TOP)/$(MCU_DIR)/gcc/libpower_hardabi.a